enquiries@phantomdrills.co.uk
+44 (0)1623 445450

Cobalt Morse Taper Shank Drill Bits (HSS-Co)

Cobalt Morse Taper Shank Drill Bits (HSS-Co)

Key Features:

Product Description:

Cobalt Morse Taper Shank Drill Bits

This unique range of Cobalt Morse Taper Drill Bits are designed to cater for all engineers drilling needs and offer a solution to all drilling problems where other drills cannot cope or stand up to modern manufacturing speeds and methods.

Cobalt HSS-Co Morse Taper Drills are primarily for drilling in the following materials:

  • Alloyed and Non alloyed Steel up to 1000N/mm2
  • Soft and Hard Stainless Steel
  • Soft Cast Iron
  • Aluminium
  • Copper
  • Brass and Bronze
  • Plastics
For the suitability of the drill in the aforementioned materials, please see our catalogue
Phantom: A range of HSS-Co drills bits that offer benchmark quality, precision ground drill bits that maintain precise diameters, thus leaving precision tolerances in drilled holes. Not only are Phantom HSS-Co drills precise, they also last longer under production conditions, excavate swarf quicker and feature a ‘split point’ or ‘self centring’ tip.

The Phantom Drill Catalogue is available for download to check the suitability of the drill bit for specific metals, here you can also check the speeds and feed rates (Please allow a few minutes for the catalogue to download). Please use the contact form or email enquiries@phantomdrills.co.uk if you have any questions regarding the Phantom Drill Bit range, our staff are always on hand to give you any expert advise you require.

12.150

Product Code: 12.150

Price: £0.00

Phantom HSS-Co M.T.S Armour Piercing Drill, Short Series. Split point. Suitable for very hard materials, manganese steel, hardox 400/500, Duromax, etc. Point angle 135°

Diameter
QTY:
Successfully Added!
12.500

Product Code: 12.500

Price: £0.00

Phantom HSS-Co Morse Taper Shank Drill, DIN 345N Ground and milled, thinned point, point angle 135°. For materials that are difficult to machine and for general use.

Diameter
QTY:
Successfully Added!
12.520

Product Code: 12.520

Price: £0.00

Phantom HSS-Co Drill DIN 345-N, type TS, for deep-hole drilling, Morse Taper Shank, milled, with split point (self centring), point angle 130°, for the drilling for steel and cast-steel alloyed and unalloyed over 900 N/mm² strength, grey cast, malleable cast, high-alloyed chromium steel such as stainless and acid resistant steel.

Diameter
QTY:
Successfully Added!

All drawings for these items are available in our catalogue on the download section of the site.